Amendment 1 to IPC-7711/21C, the document provides procedures for removal and installation of D-Pak components
Products
IPC-4554, "Specification for Immersion Tin Plating for Printed Circuit Boards," is the third document in a series of specifications [the first two are: IPC-4552 which addresses electroless nickel/immersion gold (ENIG) and IPC-4553 which addresses immersion silver (IAg)] that set the requirements for printed circuit board surface finishes that are alternates to eutectic tin-lead. IPC-4554, a full...
Enmienda 1 al IPC-7711/21C, el documento proporciona los procedimientos para la extracción y la instalación de componentes D-Pak.
Amendement 1 à IPC-7711 / 21C fournit des procédures supplémentaires de retrait et d'installation
Ergänzung 1 zu IPC-7711/21C-DE, das Dokument enthält Verfahren für das Entfernen und Montieren von D-Pak-Komponenten.
IPC-7711/21C的修订本1，本文件提供D-Pak元器件的去除和安装程序。.
The Amendment 1 to IPC-4556 made the following changes to the base specification: a) It added the absolute value of the maximum thickness for the immersion gold of 0.070 μm [2.8 μin] that accompanies the statistically valid minimum immersion gold thickness; b) It added two more photomicrograph images to provide better information on identifying nickel hyper corrosion; c) It added the basis of...
Specification for Electroless Nickel/Immersion Gold (ENIG) Plating for Printed Circuit Boards Amendment 1 to IPC-4552 replaces the Table 3-1 Requirements of Electroless Nickel Immersion Gold Plating plus also replaces all of sections 3.2.1 Immersion Nickel Thickness and 3.2.2 Immersion Gold Thickness in the original release of the IPC-4552. The Amendment 1 permits the use of thinner gold (≥4 µm...
Specification for Electroless Nickel/Immersion Gold (ENIG) Plating for Printed Circuit Boards Amendment 2 to IPC-4552 is a new section in the original release of the IPC-4552. The Amendment 2 provides the “rules” by which any rework and/or repair of a printed board's ENIG surface finish is allowed. Effective September 2012.
Coming Soon
IPC-7095E: Design and Assembly Process Implementation for Ball Grid Arrays (BGAs)
IPC-2294: Design Standard for Printed Electronics on Rigid Substrates
IPC-6904: Qualification and Performance Specifications for Printed Electronics on Rigid Substrates
J-STD-005B: Requirements for Soldering Pastes
IPC-4105: Specification for Metal Base Copper Clad laminates for Rigid Printed Boards
J-STD-004D: Requirements for Soldering Fluxes
IPC-4413: Specification for Finished Fabric Woven from Low Dk Glass for Printed Boards